---
id: obu-page
type: screen
title: The OBU page
summary: Settings › OBU (ERP 2.0) shows whether the OBU is connected, lets you connect or disconnect, lists OBUs found nearby, your saved OBUs and those paired with this iPhone, holds the one-time Setup, and has an event log for troubleshooting.
section: using
url: "https://irrhuh.app/kerbside/guide/obu-page.html"
related: [connect-your-obu, troubleshooting, settings, obu-and-erp]
platform: [iphone]
applies_to: 1.0
updated: 2026-11-16
opens_from: [settings]
---

# The OBU page

Open it from Settings › **OBU (ERP 2.0)**, or from the Drive tab › ⓘ › **OBU settings**. It's where you connect your OBU and check what's happening.

## Status

| Item | What it shows |
|---|---|
| Title | **Connected to** your OBU, **Searching…**, **Connecting…**, **Found** an OBU, **Not connected** or **Failed** |
| Line below | While connecting, the seconds so far ("pairing usually takes 10–20 s"). Otherwise the last message time, the card balance, and how the OBU pays: by card, by backend account, or no payment method turned on |
| **Connect** / **Disconnect** | Connect goes straight to the OBU found in the last 10 minutes, or opens **Connect an OBU** |
| Orange line | The latest error with its time, e.g. "Connection failed: Bluetooth off (1001)". It clears once a later step works |

Kerbside reconnects by itself when the app opens, when it comes back to the front, and after a disconnect. With a plate saved for the OBU it connects by plate; otherwise it looks for the OBU by name.

## Found nearby

OBUs found by the last search, kept for 10 minutes so you can connect without searching again. Shown only when you're not connected.

## My OBUs

Every OBU you've connected to. Tap one to:
- give it a **Name** (e.g. Family car) and a **Car plate**. With a plate, Kerbside reconnects without searching;
- see its **OBU number** and when it was last connected;
- **Forget this OBU**: removes it from Kerbside. It stays paired with the iPhone.

## Paired with this iPhone

The OBUs LTA's software has paired with this iPhone over Bluetooth. Kerbside connects to these straight away, without searching.

## Setup

- **Initialise SDK:** checks Kerbside's LTA developer key. It runs by itself when Kerbside opens, so it's normally ticked.
- **Grant OBU data permission:** LTA's screen asks once for permission for Kerbside to read OBU data. It's needed before any connection.

The ⓘ lists what to do before connecting a real OBU: disconnect other OBU apps, register your iPhone's Bluetooth address with LTA, and have internet.

## Event log

A list of what the OBU and Kerbside did, with times: launches, connections, charges, trip summaries and errors. The wording is technical. If you write in about a connection problem, a screenshot of the latest lines helps.
