Mac Display
Mac Display turns an iPhone or iPad into a status screen for your Mac. It shows big rings for CPU, memory and GPU load, plus the thermal state, network and battery, live over your local network. Prop a phone up beside a laptop and it works as a desk gadget.
Before you start:
- the iPhone or iPad must be paired with the Mac;
- both must be on the same network;
- the Mac must be sharing its status. Sharing is off by default.
Turn it on
- On the Mac: on the This Mac page, click the iPhone & iPad Display button in the toolbar. Switch on Share this Mac's status with my iPhone and iPad. The status line shows, for example, Shared · 1 device watching. The same switch is in Therbie › Settings….
- On the iPhone or iPad: go to the Mac tab and tap Open Mac Display on the Your Mac card. Allow Local Network access the first time.
If the device isn't paired with the Mac, Mac Display says Pair With Your Mac. If more than one Mac is sharing, choose one in Mac Display's ⋯ menu under Mac (or leave it on First Mac Found).
Up to 4 iPhones and iPads can watch one Mac at a time.
What it shows
- CPU with the performance- and efficiency-core split, memory used of total, and GPU load.
- Chips for the thermal state, download and upload speed, battery, and Low Power Mode.
- Live, with a pulsing dot, while readings arrive. If the Mac goes quiet, everything greys out and shows Last seen with the time (for example Last seen 10:42) and what Mac Display is waiting for. After 30 minutes it says Not seen for ….
How often it updates: the Mac sends a reading at the device's dashboard refresh rate (⋯ › Set refresh frequency: 2, 5 or 10 seconds, default 5).
Screen: Mac Display keeps the screen on while it's showing. It shifts its layout slightly once a minute so nothing burns in, and always uses a dark design.
The ⋯ menu also has About Mac Display and Stop Looking for Macs.
The Your Mac card and widget
- The Your Mac card, on the Mac tab, shows the Mac's CPU and four small rings, marked Live or with the time it was last seen.
- The Your Mac widget shows the last status Therbie received, with the time. Widgets can't keep a live connection, and iOS decides when they refresh. After 30 minutes without news, the widget fades and says Not seen for …. Open Therbie or Mac Display to bring it up to date. See Widgets.
Privacy
- Off until you turn it on. Sharing is off by default.
- Read-only. iPhones and iPads can watch, but can't change anything on the Mac.
- Paired devices only. Only iPhones and iPads paired with the Mac can watch, and the readings are encrypted on the way.
- What's sent:
- the Mac's name, chip, model identifier and macOS version;
- its live readings: CPU (including the core groups), memory and memory pressure, GPU load, thermal state, network, battery and charging.
- Unpairing stops it. Unpair a device on the Mac and its Mac Display stops at once. Its Your Mac card and widget clear the next time it tries to connect.
- No internet. Nothing goes over the internet or through iCloud.
Others on the same network can see that the Mac is sharing, because its name is announced on the network, as AirPlay devices' names are. They can't see what it shares.