Barometer
The Barometer sensor in Therbie reads the air pressure around your iPhone or iPad. Pressure tells you two things: where the weather is heading, and how far up or down you've gone. Therbie shows both.
Not every iPad has a barometer. On a device without one, the tile says Not on this device.
Turn it on
- Go to the Measure tab and tap the Barometer tile.
- The first time, a sheet explains the sensor and shows its settings. Tap Turn On.
- Allow Motion & Fitness when iOS asks.
After that, a tap on the tile turns the Barometer on, and the tile's power button turns it off. When it's on, tap the tile to open it full screen.
If you said no to Motion & Fitness, turn it on in Settings › Privacy & Security › Motion & Fitness › Therbie.
The panels
| Panel | What it shows |
|---|---|
| Pressure | The pressure on a gauge in hPa (inHg where miles are used), with weather-barometer colours from stormy to dry. A dashed yellow hand shows where the pressure was 3 hours ago, like the set hand on a wall barometer |
| Weather trend | Whether the pressure is rising, steady or falling over the last 3 hours, by how much, and what that usually means, with a graph of those 3 hours |
| Relative altitude | How far you've gone up or down since you opened the screen, with the last 10 minutes drawn and a faint line for each floor |
| Floors today | Floors climbed and descended today, and your height above sea level with its accuracy, on devices that report it |
The weather trend
Weather services describe pressure by how much it changed in the last 3 hours. Therbie uses the same measure:
| Trend | Change in 3 hours | Usually means |
|---|---|---|
| Rising fast | 3.6 hPa or more | Clearing quickly, often windy for a while |
| Rising | 0.5 to 3.6 hPa | Weather settling or improving |
| Steady | Less than 0.5 hPa either way | No change expected soon |
| Falling | 0.5 to 1.6 hPa | Unsettled weather may be on the way |
| Falling fast | 1.6 hPa or more | Storm sign: wind and rain likely within hours |
- How much data it needs: at least an hour of readings, and it gets better up to 3 hours. It's worked out from your History, so it carries on when you close and reopen Therbie, as long as the Barometer was on.
- The daily tide is taken out. Air pressure naturally rises and falls twice a day. When Therbie knows roughly where you are, it removes this daily tide from the trend. To do that it keeps a rough position, rounded to 0.1° (about 11 km), on the device.
- Height matters. Going up 10 m lowers the pressure by about 1.2 hPa, so a trip up a hill or a tall building looks like falling weather. Therbie warns you when your height changed while the trend was measured. For a true weather trend, leave the device in one place.
Storm warning
Warn when pressure falls fast is off by default. Turn it on under Barometer in ⋯ › Sensors; iOS asks for notification permission.
When it's on, Therbie sends a notification titled "Pressure falling fast" if all of these are true:
- the pressure fell 1.6 hPa or more in 3 hours;
- there are at least 2 hours of data;
- your height stayed steady.
It sends at most one every 6 hours, and only while the Barometer is running.
Floors
Therbie counts a floor each time you go about 3 m up or down, by stairs or lift.
- Small wobbles don't count. After a floor is counted, you have to go a whole floor further up, or a whole floor back down, before the next one counts. Slow changes from the weather aren't counted either.
- Floor height: if floors in your building are taller or lower, change it under Barometer in ⋯ › Sensors, from 2.5 to 4.5 m in steps of 0.5 m (default 3 m).
- Reset Today's Floors starts today's count again.
When it runs
- While Therbie is on screen.
- During a recording trip, when Record height with trips is on (the default). See Location and trips.
Battery use is low.
What's logged and where it goes
- History: the pressure is logged about once a second, with floors climbed. Open History to see it over the last hour, day or two weeks.
- Insights: they mention a storm sign (a fall of 1.6 hPa or more in 3 hours) and how many floors you climbed today or this week.
- Where it goes: pressure, altitude and floors stay on the device. They also go to a Mac you've paired, with History.
Good to know
- The pressure is what the sensor measures where you are, not the sea-level pressure on weather maps. Higher up it reads lower: at 300 m, about 35 hPa lower than the sea-level figure. The trend is what matters.
- Wind, air conditioning, and closing car doors or windows can make the pressure jump for a moment.
- A phone in a sealed waterproof case may react slowly.